Yacht for Sale | 44 Sunpower Yachts Broadbeach, Australia

From a dinghy or floating dock, you can board her on one of the 2 swim platforms that catamarans provide. In between the hulls, there is an overhead space ideally suited for dinghy storage, with protection for it by the deck above. The steps take you up to the aft deck which has a long settee and tables for entertainment or early morning breakfasts. Another set of molded in steps will take you to the flybridge. Arriving there you will have a bird’s eye view of your surroundings. There is a fully equipped helm as well as seating and tables for guests. An excellent area for socializing. Back down to the aft deck, you may enter the galley and main salon area through wide glass doors that, when opened enhance the outdoor “feel” of the interior.

Entering you have the galley to port and starboard, fully equipped for cooking and entertaining. Forward of the Galley area the lower helm is to port and a dinette area to starboard.

In this entire space we have a 360-degree panoramic view of our surroundings. In fact, you can stand on the bow and watch people sitting on the aft deck having lunch. Best hurry… don’t want to miss a meal!

Finally, below decks in the port hull, there are 2 guest cabins and a shared head and shower area. The starboard hull and forward sections contain the Master stateroom with its own ensuite head and shower. All these cabins and especially the master cabin have a light and airy feel to them due to generous use of windows and ports.

Engine and machinery spaces have appropriate access hatches at their locations in each hull.

General Interior:

Headroom in all cabins, a minimum of 6’6’
Large portlights in all cabins
Natural aeration and forced aspiration system in all cabins/heads
Thermal insulation for excellent room climate
Handrails in inox, optionally leather covered
Cabin and head doors in lightweight materials with high quality soft closure
Door locks have high quality “anti-rattle” mechanism, all drawers soft closure
Port lights and deck hatches in “flush deck” design and CE approved
All steps with anti-skid surface and LED courtesy lights
Hella LED lights throughout

Main Salon:

Spacious salon, approximately 20 sq, meters
Sliding salon door opens to full-width
Sliding window on the port side
When fully opened, this interior is virtually a large open cockpit area.
Hella LED lights
Panoramic view from anywhere in the salon
Also contains, galley, lower helm and dinette
Dinette seats 6 for dinner.
U shaped sofa, converts to bed
Samsung 42” TV with hydraulic lift

Inside, Lower Helm

Helm, with steering engine controls and displays, compass
Helm seat, 120 cm wide
Raymarine Axion GPS/Plotter
Raymarine radar
Icom VHF marine radio
Muir Anchor chain counter
Fusion marine stereo surround sound system, for salon and aft deck
Fusion marine stereo remote control
Water tank gauge
Yacht Battery power gauge
Electric outlets
360-degree panoramic view from this position
Vast storage under, with long drawers
Yacht Electric e-motor battery power meter
Luxo TV remote power lift
Horn
Light switches
Craftsman bow thruster controls

Galley:

Galley is to port and starboard as you enter from aft deck.
U shaped galley to port, L shaped to starboard with acrylic stone worktop.
Stainless steel sink, twin basins
Electric sockets on worktop
Bosch Induction cooktop with 4 burners
Bosch oven and grille
Samsung Side by side Fridge/freezer, lower drawer
Ample Cabinets and drawers for storage

Master Stateroom:

Entering from steps leading down from center forward of the main salon, the master stateroom is light and airy due to the abundance of windows. It encompasses the full beam area and the starboard hull going aft. Featuring :

Twin vanities
2 Large double beds
Office desk
Marine mattresses in PU foam with varied densities for greater comfort and restful sleep
Also, anti-mite, anti-fungus, antibacterial and hypoallergenic
Storage under the bed accessible from side or top
Hanging lockers and lockers wit shelves
Electrical outlets
Hella LED ceiling lights and reading lights by the bed
The head/shower is all the aft

Master Head/Shower:

Generous sized bathroom
Large, “King size” shower with acrylic door
Storage shelf and seat in shower
Dometic electric toilet
Bosch washing machine
Non skid flooring
Hella, LED spotlights
Twin basin sinks with H/C water mixer
Upper cabinet with mirror
Cabinet under the sink
Electric outlets
Towel holder-soap dispenser-paper holder

Guest Stateroom:

There are 2 Guest staterooms in the port hull. They are accessed from steps coming down from the main salon, port side, middle of the salon. Staterooms are found fore and aft with the shared bathroom in the middle and a hallway connecting all.

Forward stateroom has 2 single bunks
Aft stateroom has a large double berth

Both Cabins Feature:

Hella LED lights, reading lights
Same marine mattresses as master cabin
Access to the shared head/shower
Abundant natural lighting
Electric outlets

Guest Head

Dometic electric toilet
Hella LED lighting
Electric outlets
Sink with mixer tap for hot/cold water
Cabinet under, cabinet over with mirror
“King size shower with acrylic door
Non-skid flooring
Towel holder-soap dispenser-paper holder

DECK:

Transoms

Shower (H/C) in starboard transom
Inox handrails
1 Swimming ladder at transom step
l-bench at the salon-wall with a U cockpit seat and table for 6-8 persons
All voids are accessible for ropes, fenders, cushions etc.
Built in Stairs to flybridge
Electric tender lift
Tender 2.9m islander
Torqueedo outboard 1103

Foredeck:

2 deck-hatches for access to forward storage-compartments
Muir 1.200 W electric windlass (8 mm chain)
Composite day bed areas for up to 4 guests, with 2 x round composite tables/ drink holders with stainless rims.
Day bed cushions only

Deck Fittings:

8 mooring cleats total (2 x swim deck, 2 x stern, 2 x mid-ship, 1 x bow on each hull)

Exterior Decoration:

Sunpower Yachts logo on sides of coach roof

Flybridge

Port helm console for engine controls and navigation equipment
Moulded L-shaped sofa with table
Sunbeds
Fixed solar roof
E-motor controls
Raymarine Axion 9
Radar
Muir anchor winch counter
Craftsman bow thruster controller
Dock lines, fenders, boat hook and cleaning gear

Electrical:

Fuses and breakers for12v,24v and 48 v DC and 240v AC
Wired for 240 v AC
Custom electrical panel All wiring marine grade tin coated copper
All cables labelled, numbered and mounted on rails
All lights are Hella, LED

Main panel Features:

Battery level
Fuel, water and holding tank gauges.
Navigation lights

Batteries and Solar:

48 volt Lithium batteries for 80 kWh
22.5 volt House batteries, with a 50 Amp charger
60A charger for 25.2 volt batteries
5 kVa Inverter for house AC appliances
24 high efficiency solar panels with 9.6 kWp in total for house and propulsion
MPPT solar charge regulators
Charge, consumption and capacity controls for all electric circuit

Engine Details and Mechanical Equipment:

2-20KW high efficiency motors
Cruising speed 4-6 knots, max 10 knots
High efficiency props on shafts
16 kw Yanmar generator,
Access to engine and mechanical compartments via cockpit hatches
Engine compartments: natural aeration and forced extraction
Generator, engine and technical compartments sound proofed
Seawater Pro watermaker, with 50hz motor, 20 gal per hour
Hot water heater
All hoses and piping marine grade
Fresh water circuit with pressure pumps
Hand shower on transom
Holding tank has macerator pump

Bilge pumps:

Automatic bilge pumps in each watertight compartment 2 in engine rooms and 2 forward in each hull

Steering:

2 rudder blades with stainless steel shafts
Epoxy tube for rudder bearings
Self aligning upper and lower bearings
Hydraulic steering system

Construction Details:

Both hulls are light weight and flexible Western Red Cedar laminated with quadriaxial e-glass and west System Epoxy. Western Red Cedar is dimensionally stable, lightweight with high strength. It also has insulating properties to reduce hull noise, as well as being resistant to decay.
Each hull has a laminated solid timber keel and a reinforced laminated collision bow section.
Reinforced high-density foam core composite bonded with epoxy resin for a strong but lightweight structure.
Epoxy resins used for their interlaminar shear strength and resistant to osmosis.
Sophisticated highly torsion resistant hull and bulkhead structure
Watertight bulkheads, sealed floor sections and collision compartments for ultimate safety.
Foam core structure bonded with e-glass provides thermal and sound insulation.
Built in interior furniture reinforces the light weight structure.
Exterior completely finished in Jotum, high gloss polyurethane paint.
Standard build is in accordance with CE regulations.

Safety: